620軋機-圣霖國際【創新發展】-620軋機生產

軋制技術的有關問題:

般在板邊緣較薄，扎或縱厚度偏差就叫做板凸度。如果板凸度足夠大，板厚偏差可以達到一定值，以至于鋼板不適用于在嚴格要求板厚精度的場合。當厚度偏差增大（在板寬方向上厚度不同）導致在材料設計后產品損失中應考慮增加板厚邊緣。

It is thinner on the edge of the plate， and the deviation of the ligation or longitudinal thickness is called the plate convexity. If the plate convexity is large enough， the thickness deviation of the plate can be reached to a certain value so that the steel plate is not suitable for the situation where the thickness of the plate is strictly required. When the thickness deviation increases (the thickness is different in the width of the plate)， the thickness edge of the plate should be added to the loss of the product after the material is designed.

開坯機為兩輥水平軋機，圣霖國際620軋機，坯料送至軋機前后，620軋機生產，根據軋制程序表進入相應的軋槽可逆軋制，并通過翻鋼裝置將軋件夾緊進行翻轉。一般軋制5-7道次(多9道次)。

The blooming machine is a two roll horizontal mill，620軋機， and the billet is sent to the front and rear mills. According to the rolling schedule， the roll is rolled into the corresponding rolling groove， and the workpiece is clamped and turned through the turning device. The general rolling is 5-7 times (up to 9 times).

短應力線軋機具有如下優點：

⑴容易實現負公差軋制，因為軋機的高剛度保證了產品的。

⑵可實現軋機左右兩個軸承的對稱調整，這對于穩定軋制條件，提高作業率，620軋機價格，節省檢修和更換導衛、橫梁時間等具有重要意義。

Short stress line mill has the following advantages:

It is easy to realize negative tolerance rolling mill， because of the high rigidity to ensure high precision products.  

The symmetric adjustment can achieve about two rolling bearings， the stable rolling condition， improve operation efficiency， sing maintenance and replacement has important significance to guide and beam time etc.