ESTANE 58130 TPU Technical Data Sheet Type: Estane? 58130 is a 50D Polyester Thermoplastic Polyurethane (TPU). Features: Fast cycling, broad temperature performance and durability. Uses: Injection Molding. ? Prior to testing samples were conditioned at 23°C for 48 hours. ? Based on extruded sheet (30 mils). ? Listed values are “typical (erage) values” and should/cannot be applied for specification pures. Supply Form and Standard Packaging ? Estane? 58130 TPU is ailable in pellet form and packaged in 50 lb bags or 1000 lb boxes. Material Preparation ? Prior to processing, Estane? 58130 TPU must be dried at 220°F (104°C) for 2-4 hours. ? It is recommended to dry the material in a desiccant type dryer. Target dew point should be -40°C. ? Depending on the applied processing technique, the maximum moisture level should be 0.02%. Material Preparation ? Estane? 58130 TPU can be processed on any conventional injection molding machine. Physical Properties Value (Metric) Unit Test Method Hardness (5 sec) 50 +/- 3 Shore D ASTM D-2240 Specific Grity 1.23 ASTM D-792 Tensile Strength 6000 (41) psi (MPa) ASTM D-412 Ultimate Elongation 450 % “ Tensile Stress at: - Elongation 1600 (11) psi (MPa) ASTM D-412 - 300% Elongation 3500 (24) psi (MPa) “ Tear Strength: - Gres 790 (14) lb/in (kg/mm) ASTM D-624 (die C) - Trouser 240 (4.3) lb/in (kg/mm) ASTM D-470 Taber Loss (1000 rev) 0.0022 (62) oz (mg) ASTM D-3389 (CS-17, 1000g) Tm (by DSC) 424 (218) °F (°C) Lubrizol Advanced Materials Tg (by DSC) -40 (-40) °F (°C) Lubrizol Advanced Material