簡介: ◆此結晶粉是意大利進口的一種理石及粉質云石大理石的結晶晶面護理產品。主要是利用拋光墊在機器重力及旋轉力的摩擦作用下所產生的熱能,滲入石材毛細孔內并在石材毛細孔內快速產生化學反應,從而令光澤度不明顯的云石表面覆上一層薄薄的水晶層面。石材表面光澤度透明,立體感及層次感分明,對石面進行強有力加光、增硬及防滑護理。 使用方法: 首先確保石面干燥潔凈,用清水把本品調成稀糊狀,用多功能擦地機配合百潔墊打磨地面至半濕狀態(磨干了會加大阻力,有損機器設備性能),用清水過滌,并用吸水機吸除石面水漬雜物,待石面表干后即可出現高光晶面效果。 注意:結晶粉是呈酸性,拋光作業后,要及時以清水充分過水并吸干,避免石材被殘留的酸性成分燒灼退光。(萬一因作業速度過慢,石材產生退光燒灼現象,只需再次進行拋光結晶,即可恢復亮度)。 Description: ◆ The crystalline powder is a kind of marble imported from Italy and silty marble marble crystallization of crystal face-specific care products. Mainly using the polishing pad and the rotating force of grity in the machine under the friction heat generated, infiltration of the pores within the stone and the stone rapid chemical reaction within the pores, so that the surface gloss of marble, covered by a layer of obvious thin crystal dimension. Stone surface gloss transparent, three-dimensional and layered clear, strong increase of the rock surface to light, hardening and non-slip nursing. Usage: First of all, to ensure that stone surface clean and dry, with water to dilute the product transferred into a paste, rub with a multi-function machine with the scouring pad to polish the ground to the sub-humid conditions (dry ground will increase resistance, undermine the performance of machinery and equipment), wash with water over and sucked with the suction machine stone surface stains and debris to be rock surface is dry there can be side effects of high optical crystal. Note: The crystal powder is acidic, after polishing operation, to full time over the water with clean water and dry to oid the stones were left burning acid coition back light. (If too slow due to work, back light burning stone produce the phenomenon, simply re-polishing crystal, can resume brightness). 工藝原理 晶面處理就是利用晶面處理藥劑,在晶面處理機的重壓及其與石材磨擦產生的高溫雙重作用下,通過物化反應,在石材表面進行結晶排列,形成一層清澈、致密、堅硬的保護層,起到增加石材保養硬度和光澤度的作用,本品為獨特工藝配方,使用石材表面產生化學雙重反應,能同時使石材增亮、加硬、防護,并具有防滑、防腳印、防劃傷的保護作用。 晶面處理工藝特點 1.光澤度高,可達100度以上,基本達到新出廠石材的標準。 2.硬度高,不易劃傷,一般硬物(或自然行走)不會對石材造成磨損。 3.均勻、平整、光滑、天然、清澈,有鏡面感覺,顯現石材天然色澤。 4.表面干爽,不吸附塵埃,塵埃沙粒僅停留在表面,易清理。 應用行業: 特別適用于大理石、石灰石等含鈣量多的石材,處理后的板材表面晶瑩剔透、色彩飽滿、光澤度高、板面硬度提高、耐磨損、耐粉化不易腿光。 大理石結晶粉 一、性能描述: 大理石主要成份為鈣鎂鹽,化學性質較不穩定,經過翻新拋光后,為了增加表面硬度而采取的工藝 ( 玻璃質化 Vitrification),目的是固化表面分子結構、增加耐磨度、加強大理石表面硬度。大理石結晶粉可將大理石表面的碳酸鈣分解并使游離出石材結構,隨后藉由結晶粉中的活性離子與表面溶離的鈣離子反應,產生堅硬致密的鈣化結晶物。因此結晶后表層會較具耐磨耗性且不易刮傷。若處理得宜,其晶化表層結晶狀況致密良好時,對石材光澤度提高及防污,防水性亦產生一定效果。 二、主要成份: 無機酸、復合材料、SH-98、SH-98W、SH-98WF 三、注意事項: 1、處理不當或時,結晶層有可能導致原有的大理石表面色澤及紋路偏離原有狀態,造成色差。 2、晶化劑系強酸性處理劑 ,宜特別謹慎,避免傷害。 3、處理前石材表面必須完全潔凈,否可能會造成表面光澤不均。 4、使用質量差的結晶粉時,有可能會堵塞石材呼吸的毛細孔,因此宜特別注意及預防日后可能 產生的石材 裂損等病變。 標簽:
北京市大理石結晶粉
北京市大理石結晶粉廠家